![]() I have a leaking quick connect/disconnect and the leak is apparently bad enough to cause the motor to stall unless I squeeze the balb when I hear it starting to stall. Anyone have suggestions or ideas what could be causing this? But after I put it in a barrel of water, forward gear sometimes does not want to engage. * When the motor is out of the water, I had no problem going from neutral to forward. I had to make sure I was seeing it right but yeah, it's plastic. * The propeller is held on with a 'plastic' cap nut. Seriously, I wanted to just give it a good spray down and clean it out but there is absolutely no way of doing that without removing some stuff off the power head. * To get to the carburetor on this things, it seems you're required to take the power head apart. It's got some issues and I have questions. However, having cleaned everything and putting fresh gas in there, 1:32 mix with some marine Stahbil, I was able to start it. It was pretty dirty, paint flaking off, rusted screws/bolts, and I could go on. It only has forward and neutral, no reverse. I bought myself a Ted Williams 7.5 HP single cylinder, 2-cycle outboard motor with air cool Tehcumseh engine. Hello Everyone and thank you for reading my post.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |